Geeetech

Hi,
Both nozzles are fixed and tight.
on X (X-43,3Y-2) and Z (X0 Y63)it is correct.
On Y (X43,3,Y-2) the front nozzle is always touching the plate.
I think either the rods/rod bearings/spider is strange..

Hi, I recently got the G2s Pro for Christmas. Assembly was fun and fast, but calibration is driving me insane: When adjusting X and Z Tower (with endstops) everything is ok. The rear nozzle touches the Plate and the front nozzle is ~1mm above (intended for testing). But on Y Tower, the front nozzle ...

Update: Just replaced 3 of my Drivers.
in spreadCycle Mode they produce a lot of noise when powered with 12 volts.

The StealthChop works perfectly. Just remove all 3 jumpers and dont connect pin conf1-3.

Voltage is adjusted to 0,6V, works just fine.

Nearly noiseless running now.

They are compatible.
Do I need to adjust any voltage?
According to http://blog.gummibaer-tech.de/tmc2100-s ... olu-a4988/
it is not needed.

Thanks !