Geeetech

Hi again William :D OK thanks for that. Just didn't want to plug randomly and get more "poofs" from the board. What I meant by last question was that if I had blown up something on the board, could it be replaced. However I got my new fan today and tested out your advice and all is good. All fan con...

Hi I am a newbie here and to 3D printing - well electronics and mechanics in general actually. Learning a LOT. However in the process I have blown something related to my fan on my GT 2560 board. I know this as it went "poof" and there was a burning smell when I tried to connect a new one after I ki...

Ah, excellent, exactly what I needed and information hard to come by. Thank you SO much!

kindest regards
Jan

Thanks William, yes I am aware G-code is a series of commands to the printer. However my problem is that I don't see anything anywhere relating to the information I seek regarding nozzle width, layer height, speeds, etc. The G codes that are there are seem about temperature, fans, retraction and mov...

Hi I am an (older LOLS) Aussie girl and VERY new to 3D printing, but have recently successfully put together a Geeetech Prusa i3 kit. However I have really had to research every step of the way and finally, after about a month, I have been getting some fairly good prints. HOWEVER, the best print I a...