Geeetech

Using easy print to upgrade to 1.0.3 I tired using the method here on the forums at the end it said FAILED! I can’t remember if there was an error code. I can try to upload 1.0.2 tomorrow to see if there is a specific code. In the meantime since the 1.0.3 firmware is obviously bad should you maybe p...

I uploaded the 1.0.2 firmware and it failed so I had to reload the 1.0.3 firmware which still has the problem after loading it again.

After upgrading to 1.0.3 my printer does not recognize any negative coordinate values. so now it can only travel in the positive areas away from the origin. When I tried to go back to 1.0.2 it bricked my board and I was only able to use EasyPrint to get it back to 1.0.3 which obviously doesn't work.

After upgrading to 1.0.3 my printer does not recognize any negative coordinate values. so now it can only travel in the positive areas away from the origin. When I tried to go back to 1.0.2 it bricked my board and I was only able to use EasyPrint to get it back to 1.0.3 whihch obviously doesn't work...

Hello,

My D200 only goes to 230C is there a reason it is limited so low?

I use mostly all MakerGeeks filament and the MakerGeeks PLA temp is 235C, Raptor PLA is 245C, and PETG is 245C.

Is there a technical reason that it won't go over 230C? or was it just a mistake?

It's not the slicer.

Happens on Slic3r and Simplify3D and it also happens printing from SD and through USB through Repetier.

Hello,

My Rostock 301 pauses every layer leaving big blobs of filament wherever it stops. How do I fix this? Is it just a firmware issue?

Hello, There have been quite a few problems noted about the Rostock 301 and the GTM32 board specifically. I was told by Geeetech staff that it uses Marlin which is open source. This means that like many of your other printers the user could easily fix these problems themselves if there was an easy w...

I would like an answer to this as well. I have had nothing but trouble with the GTM32 board on my 301.

Mine stops for a half of a second every layer and just dumps filament in that spot before moving on to the next layer.

I want to do exactly the same thing except with single extrusion. I haven't had much luck with the "diamond" nozzle and at this point I want to just use it with one extruder with a regular E3D type nozzle.

Is there a way to just connect the GTM32 to Arduino IDE and upload new firmware?