Geeetech

Hii i have M201 3d printer recently my prints started to miss steps on the Y axis I tried to strech the belts more and it didn't help much I tried to put some machine oil on the bearings of the Y axis , i still missing steps but less I read online that incrising the voltage on the stepper motor migt...

Dear support

I replaced the heater because i wasnt happy with it.
Can i do something from the controller board side , with frimeware or with the slicer to make the heater more stable ?

Without changing the hardware again ?

Lior

Hi
I also got a new heater
Can i reconfiger the controler so it will work well with the new heater ?

Dear support I bougth prusa i3 M201 with mixer head and i was unhappy with the hot head , so i replaced it with MK8 extruder. now i alot of feachers that i dont need like mixing, so i want to change the frimeware to a version that support my new hot head. can you please direct me to the rigth versio...

i read the post and its nor the case , the i think the pla is getting to the hot head but its not melting , i know that because i pulled out the pla after i heated everything and tried to extrude some.

The fan on the hot head is always on , i will read the artical an let you know

The fan on the hot head is always on , i will tead the artical an let you know

i pluged them till the end , and its still stuck.

i sorry to hear that other people have promlems with this printer too

I cleaned a lot , it was very clogged. Now its still bearly coming out
And i think it got clogged again. Any advise?

I cleaned alot but its still not great, its still bearly coming out from the nozzel