Geeetech

Awesome. Cheers thanks for that. I'll definatly check it out. After a few months being printerless it's like learning again. Printed the geeetech lizard and it worked awesome. Next project this weekend is to install the bltouch and update firmware again. The blower motor for the hotend how many volt...

After lots and messing about and trying some other firmwares the Geeetech one for the A10m worked. I mistakenly used the one with the bltouch then changed to the one without. Working great now. Just have to tweak and check. I’ll see how the multi color lizard goes

Is there anyway to extract the old info from the previous board and flash it to the new board

So there is no that can be compiled for an A10m with arduino to reverse the filament motors.
I hope this isn’t the case cause that seems Geeetech isn’t showing support for their products.

I’ll try to flash one of the hex files shown when I figure how that’s done.

Ive been looking to see where the firmware is for the A10m and don't seem to be able to find it, and how to edit it to reverse the extruder motors so they reverse the motors. I cant understand why replacing the motherboard you have to go through all this trouble of fixing things up. Can a post for t...

Thanks for the 2 replies and could you provided some details about changing it in the firmware on how to do this

Hi everyone after a delay of about 2 months I finally I put my A10 back together. And have replace the motherboard and the extruder head. After issues a while back where the temperature wasn't showing on the display yet it was continually heating up. I have a little problem now that the extruder mot...

Hi there, after finally getting some new thermistors. And double checked it and reconnected to the board to no avail. I checked it with my multimeter both at the connection and the plug. When heating the bed it still shows 11/70 and the bed heats up but the temperature isn't increasing. Is there any...

2 photos are attached. If the thermocouple is open it won't detect but the bed still heats, I'm sure this is cause the thermal runaway isn't on. Does anyone know the type thermocouple on the heatboard. Looks like that needs to me replaced.

When I go to heat up the bed the red LED under the bed is on and its heating up, but on the display is the current temperature and desired heating temperature. The bed is showing a desired temp of 70c but the other actual temperature shows 11-12c. So im assuming that is it doesn't turn the bed off c...