Geeetech

Hello,

i think my mosfet of the heatbed is dead. It doenst heat anymore.
Since i habe the Dual Head Firmware on my M201 i can use my heatbed as second extruder and that works.
How can i fix my mosfet?

I figuered out, that the 24V fuse is dead, but i already found out which fuse to buy. Maybe you should write somewhere which fuses are used in the board, so other can find easily the right one

I solved my problem. I bought a 12V Extruder for my 24V board. I burned my fuse, replaced it and bought 24V Hotend and now everything is fine for ONE extruder. For the Dual Extruder i have to get the 1.0.5 for dual head on the M201!

I want it too!

I want it too!

Hi,
i have the same problem on my M201.
The fuse IE10A has 24V, the fuse IE15A is dead.
Where can i get them? Can you send me?

Hello, i bought for my Prusa M201 a Mk8 Dual Extruder, I also bought the Geeetech Mk8 Dual Extruder holder i have a few questions and problems. 1. I cant reach the x-end stop now. The extruder hits the z-rod first. 2. The nozzle is higher than the x-axis holder where the bearings are. 3. It is trick...

Hello, i have a Geeetech M201 (GTM32 Rev. B Board) and everything worked very well. Now i decided to get a MK8 Dual Extruder. I changed the thermo cable and the heating cable. Extruder heated up to 210°C and then my printer made a beep sound and shut down. Now the printer does the following things: ...

Hi, 1.I don't think the infrared thermometer can test the exact temp...But why not increase the original temp by 20 degree since you've found a 20 degree to have a try? 2.You can check if the PTFE tube was plugged deep enough,look some guys' tips in this post: viewtopic.php?f=19&t=17372&start=20 3....

Hello, i bought my Prusa M201 some few months ago. I enjoyed to assembe it. Everything worked fine with using Repetier Host duing manuall moves, like moving the axis, pulling filament into the extruder, heating the nozzle an bed. Then i tried to print, but never had sucess till now. I had to clean t...