Geeetech

Hi I am fairly sure it is because the arms are different lengths. I was very disappointed with the quality of the parts in the kit, I had to modify several of the parts to make them fit. The arms in particular .....I tried to correct this by crimping the 5 of the aluminum rods to make them as long a...

Hi I have delta restock G2. I think I now have auto bed leveling working however I would like to increase the size of the grid it probes, but I do not see ho to do this...could somebody please assist. Below is the relevant section of my configuration.h. Also the head does not move up 50mm after prob...

Hi I am having real trouble because the spider on my delta printer does not seem to stay in the same plane which makes it impossible to set the second hot end so it does not attack the print. I have leveled the bed and set the limit switches many times, but I am unable to get it so that both hot end...

Hi So now my problem is setting up auto levelling. In Marlin configuration h I have changed the z level offset for the probe and to what I think is correct and changed Z_raise after homing to 50. I have added G29 to the special codes of slic3r and uploaded the firmware again. When I run G29 the mach...

Ooops,sorry, operator Error. Don't realise the codes took the head down to z2.
Very sorry and thanks for you patient replies.
Thanks again
Aa

Hi Nope. I am unable to get z to be zero when it is on the bed of the printer. Somewhere there is a piece of code that says it is 2mm above the plate when it is actually touching it. When I run Code 1 it goes nicely right to the plate, but z reads 2mm on the top bar. When I try to print it tries to ...

Thanks for reply After homing the printer I jog it down to the bed, in the repetier host, the coordinants read x0x y0 z2. If I look on the lcd screen under movement z offset reads -2mm I have overcome the problem by changing the height of the print area to 2mm less, but I would like to make the offs...

Hi Geeetechers
I have Delta Rostock something or other and for some reason I have a Z axis offset of 2mm which has been dogging my efforts at a first print. I don't know how it got there or how to change it. I presume it is in the firmware some where. Please help
Thanks
Aaron

Hi
I have just built delta rostock, powered it up and connected to ubunu laptop. I have downloaded the firmare and installed the driver to the laptop. However when i connect rostock to the laptop it does not see it. What am i doong wrong.
Thanks in advance.
Aaron