Geeetech

Just tried again ,for at least 6 attempts and got the same thing !

see attached file !!!!!

??? There's more thsn one kit ? I asked for whatever it took to upgrade to the GTM32 Pro control board, and not knowing for sure what all was required I accepted your reps recommendation and ordered that . I received the control board ,2 conversion boards and wiring harnesses ( I was short 1 extrude...

1. I The kit I bought did not have lead screws in it, but I do have a set of 8mm leadscrews with 2mm pitch dia. that I can install. Will these work? I have the original threaded rods supplied with the M210 kit I bought a year ago. 2. I double checked the firmware , I have the correct one.

What are the correct Z steps settings for this board ? the firmware on the LCD reads 80.0 stepps for all 3 axis, the stepps calculator in Repieter host calculates 2560 stepps , but when I got it up around 800 stepps everything seemed to lockup. So I re-installed the firmware and set it back to 80.0....

the different types of electrical plugs and sockets 2/3/4 pin etc
JST-XHP ,JST 2.0mm PH etc.

eventually the heated bed mofset burned out ,requiring me to order a new control board.

I'd like to know What style of connectors are used on the GTM32 and GTM32 pro control boards.

!. What is the expected amperage for the heatbed ?
2. What is the expected amperage for the hotend ?
3. also for the motors,fans etc.
when I get my new control board the first thing I'm going to do is check amperage on each individual
item and total them up !

You stated that M201 printers ship with 24v 18.8A power supply, but my parts list states 24v 10-15A power supply and that is what I have (see picture)

I am heating the bed to90 degrees C and the AC switch is set on 110V for my area.

No abnormal readings when checking the heat bed either !