Geeetech

Hello all, I have a Prusa I3 Pro X that came with the single MK8 extruder. I have upgraded it to a V6 J-head hotend. I want to add another J-head to make it a dual extruder. I bought a second stepper motor and the motor driver. Both hotends will heat up but only one stepper motor will turn. The othe...

I have a Prusa I3 Pro X with a GT2560 board. The printer worked great. I dont know what i did. I was messing around with the firmware and now my Z axis will only move down. It will not move up at all. I will hit the end stop and stop. But if I try to home it again it keeps trying to go down even whe...

Hello all,
I have a pursa i3 pro x. I recently installed a second mk 8 extruder. I uploaded the firmware for the pro x dual extruder. The problem im having is that second extruder motor is not working. The hot end heats up just fine. Not sure what to do at this point. Any help would great!

Thanks

Hello all,

I have a Prusa I3 Pro X with a GT2560 board and a MK 8 extruder. I bought a second extruder and trying to figure out how to set everything up on it. Not sure where to start. Any help will be great. Thanks!

Jason

How do you would you adjust the couplings?

Thanks

I doesn't seem to wobble or make any usual noise. after every movement one side will be slightly higher than the other. It seems like one stepper motor is maybe moving faster or rotating more than the other.

I have a GEEETECH Prusa I3 Pro X and before every print I have to level my Z axis. After I level the axis it becomes uneven every time I move the Z axis up or down. Has anyone else have this problem? And is there any fix to this problem?

Thanks,
Jason

Hello All, I have an Inductive Proximity Sensor Switch NPN DC6-36V that I got off ebay and trying to connect it to my GEEETECH Prusa I3 Pro X with a GT2560 control board. I'm really sure how to make the connections. Also do I need to get two resistor to add to the sensor? I'm really getting tired of...

Hello All, I have a GEEETECH Prusa I3 Pro x. The printer worked great for the first couple of weeks but now I'm have a issue the Y axis. It will sometimes get stuck and mess up the prints. It will work fine for the first couple of layers than I will hear a grinding sound and the build platform will ...

I have a Geeetech Prusa I3 Pro X. My problem is the Y axis keeps getting stuck. When printing the platform will get stuck for a sec and really mess up my prints. I replaced the all the bearings on the build platform and greased the rods at least half a dozen times. Also messed around with the tensio...