Geeetech

so just the plus and minus on fan 1 for example

right ?

hello I'm trying to mount the e3d hot end to my prusa i3x but one problem I don't know where to connect the fan the small fan only the have 2 wires red and black but the geeetech motherboard only have the mount for wire with 3 wires red blue and yellow I don't have to match knowledge of this topic s...

i was just wondering if i can use the mk8 extruder and make bowden extruder or simular setup like m201
the motors mount is on the top for the filament extrusion and the hot end is on his original place.

https://rpkqza.by3301.livefilestore.com/y3meqGIIUrjMGmvMO0ce6Hnr8fOpe5c-YGUIiyg4VQ1N0SFnPGyseKkVhkARWBtq5xaPAc-xibEhTqrDJErmyvEpxlGQhHzPB3mu3aAHzFjsOJ77UcORGCecy2wbBYQ9U4cIIfjAm070syDLSZ5ynpnc3zopWC--AWrB2uiDsWIV7E?width=1185&height=960&cropmode=none btv can someone tell my where i can make the cur...

1. yes the end stops works. its was just my thinking they where not working
2. just needed to tight the screws on the bearing more and put more wd-40 on it
3. i had the thermistor for the heater of the extruder on the wrong place one the motherboard

Prusa i3x not working nr. 1 the end stop Y and X axis End stopper seem not been working - its like they still have force on them when they hit the end stop https://r5l37w.by3301.livefilestore.com/y3mGk0VAl6d1UWhvayZ8fY4G2mht8vZSUkQLP9_8rhmM857s0nV52Z7_2j7eH4VmB-Nm6Jh9RGNSXWkh9-oHizhzhWkS7C7T0QLOOen...

alright mark thank you so much you have been super helpful

Heat bed - Thermistor 1. i did accidentally remove the tape off the heat Thermistor and im not sure how it should be. mine looks like this. https://rplw7w.by3301.livefilestore.com/y3mVJk1vT5vePoLlSSxE9pvUX83gw_PSdMrYIADmbUtHADLJQ6WEGwzcCAzLfVsZlQCD4dV5goaaJ_WnQLkWiDR8QJos37I3fEyQB6Av5Ldi2QU98UMFhVc...

i was just wondering up and down are kinda stiff,
and i was wondering if its ok to use wd-40 or some other lope to make it slide more smoothly i am talking about putting it on the e smood road

yes did not understand first what you did.
but when i figure it out seams to work fine.