Geeetech

Hello! When I plug in the end stop plug for the bed the 3d printer starts turning on and off. I have tested with switching the endstops but the problem is still there anyway. If I unplug it, then the printer startsup, although I am not able to do the Auto Home command probably due to the missing end...

I found the error. It comes from one of the endstop connections. There must be some fault on the middle port for the endstops. If this is plugged in the printer turns on and off. Holding the endstop connected to that port down, or removing it from the port turns the printer on.

br
Lars

Ok, I found the error.
Seems to be something with one of the endstops.
If I disconnect it then it seems to work, so I probably need to get a new endstop then.

br
Lars

Hello Mark!
The LCD has only the backlight, but it seems to be turning on and off. Also the fans seems to go on and off. Nothing else is working.

br
Lars

Hello!
I have just assembeled my I3 Geeetech 3d printer. When plugging into socket and turning power on, the LCD just blinks together with the circuit board. It seems that it turns on and off.
Any suggestions where to start finding error?