Geeetech

Disregard my post. I found the problem. I had not installed the fdi driver.

Cheers

Daryl

Hi, I had to replace the computer that was connected to my G2 printer. I have installed Repetier Host on the new computer but can't get the printer working. Repetier host does connect but I get the following message. "No Start Signal detected - forcing start" Do I have to reload the printer firmware...

THANKS Mark.

Hi,

Can I increase the drive to the Extruder stepper motor? I can hear it clicking and see it missing steps. I have tried to adjust the spring tension on the extruder but I still cant eliminate it completely.

THANKS

Daryl

THANKS Mark.

Hi,

I have a G2 and would like to know the function of the 2 screws on the extruder motor gear. Is there a correct way set this up properly?

Cheers

Daryl

Hi Mark,

Thanks for your reply. My printer is a G2 and works fine running Slic3r.
I have since found a resolution by Google search.
In the Start code of Cura, the command G92 E0 must be entered. Then Cura works fine.

Cheers

Daryl

Hi, I have been using Repetier Host with Slic3r. I tried using the Cura engine and have a problem that I want to fix. When I slice the job and then print the following happens:- 1. The print head moves to the bed as if to start printing. 2. The print head does not move in X/Y direction. 3. The filam...

THANKS Lar3ry

When I run bed levelling, where are the parameters stored?
When should I run the G29 bed levelling command?......Every time I switch on the machine??

THANKS

Daryl