Geeetech

Thank You. The printer works fine allready.

In my opinion it will be better the alumunium plate on the bed to be minimum 7mm. Mine is without parallety.


Best regards

I don't think that is the decision.
I mean there is the problem, where is the 0 point.
Are You sure, that we have problem with the direction of the rotation of the motors?
We are with different mainboard. How can I open the firmware, if it is nessesary?

Thank You for the help. We have found a "working" system for now. One of the problems was, that only one of the nozzles and one of the thermistors work. With another version of repetier host we are almost done. But we haven't found solution for now for the axis. When I give home (X0,Y0,Z0), it goes ...

So I have succeed to start the printer with Repetier Host 1.6.
But I still have a problem with Xo and Yo.
The second problem ist with the extruder heater. He wouldn't start? Why?

Yes, LCD works. I have tried all the rate untill 230400. Nothing happens.

Yes, It shows only, that 6-7-14 commands waiting.
This is down in the middle.
Any advice?

Yes, I am with this driver. When I connect usb cable of the printer, It connects to COM6.
If I try in Repetier Host another Com, It gives a mistake.
When I connect Com6, it says nothing, but I can not move , nothing. It looks like as not connected.
What can I do?

Thank You, the firmware is updatet.
But!
I have installed Repetier Host 0.9 and 1.6 and a couple of drivers. The printer can not be seen.
Other problem that I have is with positioning x and y.
Please help

Hello, friends.
I need a firmware for Geeetech Prusa I3 M201, GTM32.
Thank You

P.P. kto@progress-sz.com