Geeetech

Thanks, it all works perfectly.
Just a small regarding noise. Should i bring the power down to the step motors?

Hi Mark, finally I got the printer going. The issue with the 2 Z axis step motor had to do with the connecter being defective. The red wire was not connected in the connecter…. It looks like a manufacturing defect… After I fix it, I had to calibrate and fine tune the configuration.h file. Once that ...

Hi Mark thank you for your fast response. By increasing the power to the step motors (by turning the small screw on the drive connected to the sanguinololu ver 1.3a board) it seems to have fix my z home issue. But now I can not jog the z axis using repeater-host. Only one step motor turns and the ot...

Hi I got somewhat of a proper configuration.h setup. Now the issue is in the z axis step motors, one is turning left and the other one is turning right. Does anyone know what is the parameter to change to fix the issue. And I did a bou bou the version of the card is 1.3a and not 1.39... the a is in ...

Hi I have a sanguinololu rev-1.3 board and a Prusa I3 in Aluminum printer. The Z step motors don’t seem to have sufficient power to move the extruder. But when the step motors are not connected to the rods, they function properly. And I can turn the motors easily by hand when the power is off. Every...

Thanks Mark did that but now my x axis is no longer moving. For your knowledge, I also had to go back to version 1.0.1 of Arduino in order to see the proper hardware. I could not get version 1.6 to see the proper hardware resulting in a timeout issue. I ma rightnow assuming that my configuration.h f...

Hi, can someone create a link to the proper firmware for a Reprap Aluminum Prusa I3 using a Sanguinololu ver 1.39 board.

I can not find the I3_SANGUINOLOLU files anywhere.

Someone did send me the Marlin files but the configuration.h files was not setup for a Sanguinololu board.

Thank you