Geeetech

Hi Guys, I have the Aluminium Prusa I3 with Sanguinololu controller. I've been reading a lot of forums/tutorials/etc about calibrating the extruder and stepper motors. Most of them talk about modifying the settings in configuration.h, re-compiling it in Arduino and uploading again. However, I notice...

Thanks Mark,
I have now corrected the extruder Steps/mm, but what about the feed rates and acceleration? Do these look correct. I'd still like to see a screen shot of the other settings.

-Thanks

Regards
swanny

Hi Guys, I have the Aluminium Prusa I3. I'm close to getting it working, but I having a few issues getting filament to lay correctly. I think I just need to pay some attention now to the stepper and feed rate setting in eeprom. I suspect the Steps/mm for the extruder are incorrect, but I can't find ...

Yep! you're right. Bugga, I didn't think of that one. -Thanks

Hi There, I have the Aluminium Prusa I3 printer with Sanguinololu Controller. I'm having some problems getting the SD card reader to work. Could you advise if there's any limitations on the SC card slot. Eg: * Max card size * FAT type - FAT/FAT16/FAT32 etc * Max filename length When I insert the SD ...

I think it's not mirrored, you assembled them in the wrong direction, reverse it 180°and you'll work it out. No, It's definitely mirrored. The hole for the knob and the mounting holes for the controller PCB should be on the right of the LCD. If I turn XZ plate around 180° then the X-axis motor hits...

Hi Guys,
I recently purchased one of your Prusa I3 Aluminium kits and I have encountered a few problems that have occurred during manufacture"

• 1 Cut out for LCD display backwards:
  2 Mounting holes for Y-Stop and Z-Stop switchs drilled to M3 instead of M2.5

Any Suggestions? - Thanks