Geeetech

Hello I know a lot of things about 3d printing but it is all background information. The probably the most important that i dont know is firmware and controller boards. I want to install bl touch and filament break detector on the gt2560 but have no idee how. Voor what i understand is that you use p...

hello

i cant find the firmware toolkit guide for windows, i found the one fo mac but not for windows for my prusa i3 pro c

thanks

hello,

how can i see the current firmware settings that i have in arduino and adjust it

thanks

steven

hello,

can you explane how to upload and CHANGE firmware?
when i upload it i see different lines like steps/mm etc. in the firmware.
can i change the line by just typing something different in that place or do i need special M command to do it.

thanks

yes i know in this simple picture it is the correct solution but in my object i want to print is not possible.
this is just schematic picture.
i wonder if it was possible to print every layer with an overlap of say 50%

thanks

hello,

say i would like to print a bended bridge (picture will follow).
is it possible to do it without support and manipulate overlap layers with extrusion width?? so every layer overlaps the other so i can print in a slightly angel and make a bow

thanks

hello, it's ok that i level one extruder one the printer bed but the second one is not the same hight as the first one. i looked for solution and found one your site a picture that you have to losen some screws but the screw on the picture are the one who holds the motor carriage part tot the x-carr...

hello, finally try to configure my i3 pro c. still some troubles in paradise. when i want to home y then the bed moves to me en doesn't move away from me to the endstop so when it reach the max position towards me the motor doesn't stop running and i need to hit emergenci button. when i home the z d...

Hello,

The blue printed part on the Side of the x carriage, Side where ventilator is mounted and where the controler bord is fixed cannnot pas the ventilator, so the x carriage cannot lower to the lowest position.

Did i doe something wrong in the assambly?

Thanks

Steven

hello,

in the diy kit are extra heat sink parts that are registered under part number 55 en 56 where do i use them for?

thanks

steven