Geeetech

Hi All, I am calling out for help from anyone out there.......i have spent the last days building and calibrating my Delta Rostock mini G2s to the last milli meter. All went well and must admit was quite a fun experience but now i am stuck!!!! I tried to do my first print and first the Extruder woul...

Dear Rick, I was reading your posts and i am in the same situation, i am new to printing but managed to set up my printer correctly after a quite a few days. New that its done went to do the first print and my hot end melted!!! i have the Delta Rostock mini G2s DIY kit with auto-leveling, so i chang...

Hi,

I have the same problem, did my first print and not even 10 minutes into the print the metal part came loose and the plastic around the head melted. Can you please tell me what you did to get another one and to solve it so it does not happen again,

Thanks

Did you solve it by tuning around the half bracket?

Hi,

I have the same problem, was it was it the case of an "inversed half bracket"? Or was it something else before i go ahead and disassemble

Thanks

Dear Mark, Thank you again for all your help, i purchased the printer from a reseller on eBay, it came sealed from Geeetech with a paper listing all the parts and a small book explaining some of the parts but no software settings. I also downloaded the full building instructions from the Geeetech we...

Dear Mark, Thank you for your reply and your help, if i am understanding correctly i should use Arduido 1.0.1 and the firmware you attached. Also i need to modify some number in the configuration.h file. Is there a guide i can find online somewhere to see what numbers i need to modify? as i am not s...

Hi, I am new to this and not very good in programming, i following the building instructions and reached Step "9.1 How to modify and upload firmware." As i am not to fluent in the use of code do i need to do this step or this is only if you need to modify the system? As the instructions says to : 1....