Geeetech

Hi,
the firmware works great,
needed to change the turning direction of the extruder and max travel limit but after that it works fine,
i dont think you can set it on/off from repetier its just hard coded in the firmware.

Thanks!

oke great.

Just to be sure can you also send me the original firmware?

Thank you,
question about the firmware. whil this always do ditto printing or can i set it on or of?

Hi MArk, The objeect i need to print are very small and it is possible to "Ditto" print them. i need to print 300 of them and it would help me a lot if i qould get it working. Qould i use a Y cable and just connect both steppers to the same wire ? Or will this burn my stepper driver? The Z axis is a...

Can i use repetier firmware for my printer ? And can you send me the settings from the merlin firmware ?
Repetier does support ditto printing.

I have posted a message here a few times but my messages never appear on this forum
also contacted you via email without success .

My printer is good but no service add all. Will never buy here again.


Very very bad

I have a prusa i3 with dual extruder how can i print 2 of te same objects add the same time?

Hi i have i3 pro C dual extruder and i want to print 2 of the same objects add the same time (Ditto printing)
How can i do this ?

i tryed M280 S1 but that did not work,
maybe my firmware doesnt support it ?
What firmware should i use?