Geeetech

The movements are not constant. Sometimes the 50 it will move 50, other times it does not move 60.

So the issue are not consistent and I am leaning towards that I have a bad GT2560. I have followed all of the steps to calibrate it. I have reviewed all of the code, and no one else seems to be having this issue. I need to get in touch with Geeetech and see if they can send a replacement board. I am...

I know what board Geeetech provides. That is not the issue. You need to watch the video to understand the issues I am having. The movements are not as they should be. I used the IDE firmware that was provided to me. Is there an updated version that you are using to load the Marlin software onto the ...

I am not sure if my response went through. I am not sure what you mean by lose, but the end stops are working perfectly. Its more of an issue as I described that the movements are not consistent. You can even see in the video when I was moving on my x axis it was not only moving on the x axis but on...

I am not sure what you mean by lose. The end stops are functioning just fine.

https://youtu.be/hZloV6TjvL0

I need help. https://www.youtube.com/watch?v=hZloV6TjvL0 The movements are not as they should be. I am applying the full 10 steps and they don't move the full distance until it is unrestricted by the weight of arms or as it appears. I am not sure what I need to adjust to make this work. I can't cali...

To all Delta users, I have a new G2S and still in the initial setup but I am having issues with the manual controls. I have noticed that movements in certain directions such as left on X-axis,up on Y-axis, and down on Z-axis when doing steps of ten are moving steps of ten. But as I move the machine ...