Search found 2 matches

by TheDraac
Sun Jul 26, 2015 4:43 am
Forum: Assembly
Topic: Z top mount holes too small for threaded rod
Replies: 5
Views: 9637

Re: Z top mount holes too small for threaded rod

Hello, I had the same issue. My final solution was to drill out those two holes with a 5/16" drill. I was going to use an 8mm drill but had issues finding one quickly without ordering one. A 5/16" drill is about .003" SMALLER than *mm, so you may have to "wobble" the drill around to get it to drill ...
by TheDraac
Sat Jul 25, 2015 11:03 am
Forum: Assembly
Topic: Z top mount holes too small for threaded rod
Replies: 5
Views: 9637

Re: Z top mount holes too small for threaded rod

Hello, I had the same problem. My final solution was to drill out those 2 holes with a drill. I originally wanted to use an 8mm drill, but settled on a 5/16" drill bit. If it is still a little snug, just wobble the drill around a little bit to get the drill to drill over size. I don't think a sloppy...