Geeetech

HI, I go through the set up procedure and everything was fine until G29 auto leveling i do a G28 command , fine then when i ask a G29 auto level head go down (half height) then start to move in 16 different location but going solely up between each point: going to a point , move up, another point, m...

Thanks a lot...

Tip for mac users:
don't use others versions than arduino 1.0.5, to upload firmware
even if you have ftdi drivers installed, be sure to update to the last one

HI,

need to modify firmware for a gt2560 on a g2 delta (to change radius)

where i can download it ?

thanks

Hi, I face a lot of serial communications errors , sometimes i have 5 minutes with no problems then too much errors (resend or wrong commands or n 'waiting commands) to use the printer don't know what to do i checked serial speed/stop bit/parity: 250000/1/no cache size 63 i tested change of usb cabl...