Geeetech

The molex connector is not good. The pins and sockets are not made of good materials to support high currents. Mine burnt out after some heavy use on my G2S. I de-soldered and threw away both sides of the connectors. Cut off a short length of the wires and solder 2 pieces of XT60 connectors to them,...

I took the trouble to type and list down all my problems but why did you cut out all the rest about the faulty and poor quality parts? You should be transparent. I will reach out to your customer service but my email is now down.

Not yet. I will try later this evening.

My Z offset is 1.10 from the LCD screen. Does it help changing this? I read about getting steps per mm right. Mine is supposed to be correct at 80 for x, y, and z axis. So do I set to 80.52 instead to get it right and re-calibrate the diagonal rod and delta radius? I set my diagonal rod to 200 inste...

I wanted to post a new topic. I will post it here instead. After putting everything carefully together (and constantly checking all the online exchange in Geeetech Forum) I powered up the printer but I get are 2 lines of blocks on the LCD display. I can connect from Repetier Host but it keeps gettin...

This is my measurement

I printed 20 mm calibration cube. My measurement is below. X and Y is very accurate but Z (height) of cube printed is out by 0.13mm. The difference may look small but when I print higher or larger object e.g. 50mm cube, it will increase. Also, it may cause screw holes to be oval and not circular. Le...

I do not have PLA now which I will order. What is the setting for ABS? Please reply to my earlier questions especially the vertical dimension accuracy. I can't print the plastic parts if there are inaccuracies. Sorry to keep bugging but I do need to get good after struggling more than 2 months befor...

I do not have PLA now which I will order. What is the setting for ABS? Please reply to my earlier questions especially the vertical dimension accuracy. I can't print the plastic parts if there are inaccuracies. Sorry to keep bugging but I do need to get good after struggling more than 2 months befor...

To reprint the plastic parts, what infill % should I use for ABS? Are the plastic parts that are shipped with G2S made of PLA or ABS? Thanks.