Geeetech

I will try checking with a mulitmeter this evening. As I stated I do not have LCDs with my printers, but Repetier Host registers no temperature readings with the new board. Looking at the diagram provided, I'm not even sure where to put the positive and negative probes of the multimeter to test the ...

As I stated on the 7th and the 8th- all of the external hardware works. I hooked it up to a different Geeetech Printrboard Rev D and everything works. Thermistor provides output temp, heater cartridge heats up the hot end to required temps, all motors function in both manual and print mode. The only...

I'm wondering if there is any movement on this issue? I posted a reply several days ago, but it has yet to show on the board. I am looking for a resolution on this problem- ideally a replacement board as I would prefer that over a refund.

Thanks,
vbsargent

When hooked up none of the motors moved using the Repetier Host manual commands. Also the thermistor would not register, nor the heater. using the "home" button would make the motors move. When I hooked up my other Geeetech Printrboard Rev D, everything worked. Reflashed both using the same exact fi...

Using Repetier Host's manual commands nothing moved, couldn't heat the hot end, thermistor registered no temperature. Using the "home" commands in Repetier Host, X,Y, and Z motors all moved. All functions hardware works using my other Geeetech Printrboard (same exact board, flashed with same exact f...

I was unable to hook up my "Geeetech Printrboard Rev D" board until recently, and when I did it did not work. I successfully flashed the board, and it even responds to the home button in Repetier Host, but it will not move the drivers or even recognize the thermistor (My other Geeetech Rev D board w...