Geeetech

G2

While I was going over the printer this evening tightening the nuts and screw I started messing with the effector. I discovered that the actual print volume will be closer to 125 x 200mm and not the 190 x 200mm as advertised in the spec! If I try to move the effector past the 60mm radius the rods tw...

Hi Eric,

My printer is a G2.

Okay so I eventually figured out the PSU sent with my kit my dead. While I wait for the vendor to get back to me about replacing this I built my own out of a Pc PSU. I am only using this so that I can calibrate my machine ready for when I get a replacement. Now the firmware situation with this print...

There are no lights on the board until the USB is plugged in.
LED on the board will flash a few time when pressing the connect button in Repetier.
There are no lights on the PSU, should there be?

Hi, I have just finished building my G2 and have updated it to the latest firmware. Lcd works fine when connected to USB and psu is connected up. I can not get the slightest movement or sound out of any of the motors. No fans work. Heat bed does not heat up and its led does not comes on. Extruder do...

Hi, I have just finished building my G2 printer but I am now afraid to start it up after reading this forum. Has anyone successfully built and run a G2\G2S ? I think the kit has great potential but has poor quality control on some parts. This along with the supplied firmware snapping parts before it...