Geeetech

My problem solved by changing another control board from saler...
Thanks.....

Eric wrote:

Hock wrote:I also wish got someone tell me how to do now.....

If reloading the firmware doesn't work,please leave the order number or contact the customer service.

I buy from ebay,
transaction no is : 1391549858018

I also wish got someone tell me how to do now.....

Dear friends please try the following ways to solve the problem. 1.the extruder will move until the temperature was raise to 180 degrees for PLS,240 degrees ABS.Please check whether the extruder is heated up. 2.please swap the driver board with x-axis,if x-axis is working,the driver board is good. ...

Eric wrote:hi ,you try to check the subdivision of stepper motor.

My is jumper inside....Being check , all ok

zhangxueyou wrote:Have you raised the temerature of extruder?
Is the extruder motor moving with no filament when it's connect to extruder mtor slot?

Yes, tempreture in 210,
The motor not moving with filament or no filament when connect to extruder motor slot.....

Please Help.....

zhangxueyou wrote:Have you raised the temerature of extruder?
Is the extruder motor moving with no filament when it's connect to extruder mtor slot?

Yes...temperature 210..
No...Extrude motot not move with Or without filament...when connect..

Hi, I have a Acrylic Geeetech I3 Pro B With GT250 control board & A4988 motor driver, I set up every thing , & tested....X,Y Z motor work fine,but Extruder motor not working.. temperature of extruder ..check spring tight ..check motor driver.. check plug extruder motor wire to x motor slot.. check E...

1. Extruder motor does not work To protect the extruder motor, the extruder motor can not move unless the temperature of extruder is more than 180 degrees. 2. Extruder motor can move with no filament, but it can not move with filament(moving forward and backward). 1) Check if the nozzle is jammed: ...