Geeetech

Hello Folks, after more than a year of having the printer in storage, I finally have time to look at it again. Sadly, my extruder has sagged a lot. I already bought a new aluminum holder from the GeeeTech store on Aliexpress, but can not find the part which attaches it to the two linear bearings. Wh...

Hello,
no, for me, neither of them worked.

Tam

Hello,
yes - the axis can be controled from both LCD and Repetier.

The Extruder can be commanded only from Repetier.

Hello,
I took it from the sticky thread. Weirdly, the extruders can be turned from Repetier...this seems to be an issue of the LCD only!

Tam

Hello Folks, after a long hiatus, I am back in action. I just installed the new firmware for my Prusa I3 Pro C, and the Extruders still cannot be turned. My test sequence is: a) Preheat ABS, wait until heat is reached b) Move Axis -> Extruder -> turn pot, at which point nothing happens Strangely, th...

Hello,
whoops, misunderstanding.

I meant something else. Which GPIO pins of the processor on the GT2560 are responsible for the extrudeurs? I have a logic analyzer in my lab and would run a little test program on the process computer.

Hello,
big thanks! They just confirmed intent to send a new printer controller and extruder mount!

In the mean time: could you please tell me which GPIO pins correspond to the individual stepper drivers?

Tam

Hello, thank you so much for your response. Please permit me to note the following: a) Cable connection to MoBo is correct, as the board would not heat up otherwise. But this is not a big problem for now. Big problems are: a) Motor drivers work, but the extruder still doesnt. We, IMHO, are looking a...

Hello,
I now installed the new firmware, but the extruders still don't turn. This is weird, as the motors themselves work perfectly!

Tam

Picture of wrongly crimped cable. This seems to be a common error, maybe your supplier was tired. P6268172-4Cheung.JPG Fortunately, here is the repair instruction. When looking at the silver part of the cable from the top, you will see something which looks a bit like an erected hook which blocks th...