Geeetech

I swapped the Y axis connector(stepper motor connector) with the X axis connector on the driver board and now the X axis is the one acting up. So I can conclude that the PCB board is not working correctly. Maybe a firmware update could fix?

I swapped the endstop's the Y with the X but I'm still getting the same result. So the endstop is doing his job.

And also what do you mean by the Y driver board? You mean to swap the Y connector with X connector for example or to swap the servo motor?

I'm not sure what do you mean by print sth? What I tried so far is to load up a .stl file and then Run the job from Repetier-Host GEEEtech and what happened is the printer started the job but when the heat bed hit the back switch(Y axis) it just keeps trying to move in the same direction without cha...

Sorry for my delayed reply but I was away from my home so I couldn't do the testing sooner. So I run the job and then I press the rear switch while the heat bed moves backwards and nothing happened the bed keeps moving in the same direction until he hits the back and it still tries to move however t...

Trying to post a reply and it doesn't work.

I swapped the two(X/Y) endstops and I hit the Auto Home and all the axis went to the home position. Then I went into the Move axis from the Prepare menu and tried to move the Y axis back and forth and I observed that the heat bed will only move in a single direction which is backwards just like befo...

I swapped the two end stops and now when I hit Home all the axis(X,Y,Z) goes to the Home position. However when I go in the Prepare mode and try to move the Y axis manually (I mean by turning the knob on the LCD) I still get the same result(as I was getting before) the heat bad will only move backwa...

Sorry for the confusion. When I hit the Home button the Y axis moves back home and after it hits the switch it is still trying to move in the same direction for about 2-3sec. and then it stops. Another note that I want to mention is that when I'm in the Prepare mode (selected on the LCD) and then se...

Here are the photos. Please let me know if you need any more. Thanks!