Geeetech

I’m really getting frustrated with this problems. I have been struggling for weeks now and I’m not getting the printer to work. To summarize: For the problem that I cannot print. I think extruder 1 is not feeding enough filament so I did the following: I cut a small piece of filament and feed it int...

I have A4988 motor drives. (The second extruder is not working at all. If I swap the extruders and then extruder 2 is working, so I think the problem is with the driver board on the second extruder.)

Thank you. Mine is not doing that, it will move around 5mm only. I will check the mechanical setup of the extruder because I assume the setting is the firmware is correct.

I have just completed the assembly of my I3 Pro c. Everything went reasonable well. I have done my table leveling and all. when i started my first print, it started off OK but after a number of layers, it started to peal off. Since then, with about 50 attempt, I cannot get the filament to stick to t...