Geeetech

I changed the heater already and it is ok. Now the temperature of bed and extruder are ok but I do not understand, how to insert or setting the filament. I try to test slic3r file the movement of motor x,y,z and extruder are ok but it is not pla filament injected to the bed. Can you explain how to i...

How is to take out?
Thanks

Dear Sir,
I checked the connection, it is good but I checked ohm of the extrude heater ,it is broken ( it doesn't have resistance compare with the bed heater, it is good). How can I change the heater and where can I buy (I have just try to inject in the first time).

Thank you

The extruder is not heat up to set point 180 degree , it is still 36 -38 degree. The bed temperature is ok. Please advise. Thank you

Ok I understand now. Now issue 2 and 3 are correctly solved.

Thank you very much

I try to do follow this page http://www.geeetech.com/forum/viewtopic ... 20&t=16253 but there is the error as the attched picture. I do not know what can I do next?

Best Regards and Thank you a lot.

1. I remove and reconnect again,now it is ok. 2. I checked the connect of endstop of x , y and z ,there are correct as the following attached pictures, but the problem still remain. 3. Y axis moving in wrong direction, I do not have the firmware please send to sayanch@gmail.com and please tell me ho...

Iam a newest in 3D Printer so thatI have jusut finished to assembly 3D printer and try to turn on the power but I found the problem ,I need your advise please. The board type is sanguinololu. 1. There is the alarm "MINTEMP" on the LCD screen(I think temperature of extruder) but I think I connect the...