Geeetech

Just replaced the Ramps 1.4 board, and that fixed every problem I had.

I tried, it to the point where there weren't any nuts or bolts on it at all, no luck. Thanks for the suggestion though!

Are you talking about the LCD mount st the top of the printer? Of so when I get home on Wednesday night I'll try that and save myself the freight to send it back. Thanks!

I bought the printer from your company on Amazon. Here is my order number: 102-7795247-4495433. The email address associated with my amazon account is adamphlipot@knights.ucf.edu.

This morning I switched the wires on the x end stop with the ones on the y end stop. The y is now the black.wires while x is blue. The y end stop still worked with the new wires, however the x end stop did not. http://imgur.com/a/WDrsf

http://imgur.com/a/8L3Kb Here's the end stop.

The end stops are connected correctly, I will take a picture when I am home from work. That I'd the first thing I tried. I even switched the x endstop with the y end stop and then y stopped working. I believe it should be the switch.

Any ideas on what to try next?

Just uploaded the firmware I was just sent, no change, in the LCD, x-end stop, or heat bed. But the Y- axis has stopped doing it's random stepping.

My email is aphlipot159@gmail.com. When I swap the cables for the LCD the display just goes blank and stays that way.