Geeetech

I have nothing to do with 1.75 mm. The kit that I bought from you guys is for 3mm and all parts that I've gotten in for 3 mm. So as you said and like the Internet, 3mm with direct drive extruder is not possible or really hard.. In my case it's not working and just waisting all filament I've gotten f...

Please rotate the screw clockwise on extruder motor driver, the voltage between screw and GND should be up to 1V. Already tried it, the ticking goes faster and slower. But still doesn't load the filament properly.. Maybe the system isn't compatible with 3MM ? Oh, jesus, I ignored this point! I am s...

Still not working.. And no support anymore from you guys :/ Please rotate the screw clockwise on extruder motor driver, the voltage between screw and GND should be up to 1V. Already tried it, the ticking goes faster and slower. But still doesn't load the filament properly.. Maybe the system isn't c...

Still not working.. And no support anymore from you guys :/

zhangxueyou wrote:Let the fan keeping working when printing. How about the slicer setting?

Like I posted in my other post.. Here are the settings http://imgur.com/a/PPRpN

So srsly I'm just waisting filament by that the printer isn't working :/

zhangxueyou wrote:Is the cooling fan working when printing?

Tried it without the fan, and still doesn't work.. Maybe there is a defect??

Yes the cooling fan is working while printing. Printer is working like it should only the extruded is broken then because it always ticks........

1. Swap the exturder motor driver(A4988) with x or y motor driver. Check if the extruder motor works after heating. (To check if extruder motor driver is broken) 2. Plug x or y motor to extruder connector, check if the motor works after heating. (To check if extruder motor is abnormal) Already trie...

200 degrees, so yeah.. Why is it stopping :/

1. Swap the exturder motor driver(A4988) with x or y motor driver. Check if the extruder motor works after heating. (To check if extruder motor driver is broken) 2. Plug x or y motor to extruder connector, check if the motor works after heating. (To check if extruder motor is abnormal) Already trie...