Geeetech

prusa i3b, i did change the board type to ramps 1.4 in marlin, if i used the sanguino board type it will give me an error which im unable to upload let alone connect to the board with pronterface. there is nothing wrong using a firmware configured for that machine and i just have to change the board...

Can I get a replacement for this?

Here is some details
Aliexpress order number 67759751083283
link http://www.aliexpress.com/item/Free-Shi ... 86014.html

Yes, in fact, I used the same firmware that i'm using for my sanguino. But even reflashing the firmware wouldn't solve anything because it is the physical pins that were shorted within the board, the firmware is just to drive the electricity

I tried connecting the board (only with my drv8825 plugged) using pronterface, the board returned maxtemp error (no thermistor connected).

Also in accordance to voltage measurement from pot and gnd pin for stepstick, I get 0v on my drv8825, not tested on a4988 yet

Both reported max temp error, however, both physical thermistor legs are not shorted and I tried it in my sanguino 1.3a board and it reported okay at room temp of 28-32'c

I will try again on measuring the voltage value

I tried measuring the voltage reference, from the +5v point to the left of the atmega chip and the pot screw, it shows me a constant 5.0xxV even I tried to turn it on the drv8825, on my spare a4988, it shows roughly about 3.7xxV, I moved the probe to the main power input and the volt on drv8825 show...

Hi, I ran into 2 problems on my gt2560; 1. I tried to use the drv8825 that were correctly installed and everything was wired correctly, however, when the motor was plugged in, the stepstick became hot all of a sudden approx. 90'c++, and I didn't try to move the motor. Also, disconnecting the motor w...

Here is the order ID

I ordered from here
http://www.aliexpress.com/item/Free-Shi ... 86014.html

Here it is with the original silver usb https://youtu.be/a7W0yhtDXmk