Geeetech

Now its ok, the endstoppers was not working because of how it was set in marlin, i got help from another forum. The z axis had trouble because one of the z axis threaded rods was bendt. i replaced that, and now it`s working!

Yes, i did find a marlin file that i tried, that should be for ramps 1.4, but im sure the setting depends more on the model. I dont have a skype account, is it possible to send the firmware on mail or just leave a link somewhere??

1. Z axis motors is going around if i take away the screw treads, they are in the same level. still not working. 2. i have soldered one cable that was bad. 3. If i get the axis to detect the endstopper it apears to forget it. If i for example take the y axis to detect the endstopper and then press h...

Is there a marlin configuration file i can get from geeetech? That suits the Geeetech acrylic prusa i3?

It`s a Geeetech acrylic prusa i3. Btw the x and y axis just move in one direction.

My z axis motors would not move, they just jitter. I have tried to adjust the voltage on the motor driver board, but it still just jitters. Do you know why? I have tested the end stoppers at the y and x axis, it`s like the printer don`t know they are there, and if i send the axis home it just goes 5...