Geeetech

The resistance value is 1.4 Ω. I made a test heating the bed to about 106 degrees. And throughout the test terminals of the bed marked 10.96 -11 volts. Then I did another test to check the sensor measurements using a lm35 sensor and arduino. I put the sensor LM35 on the crystal and when the thermist...

Hello, I bought the JIETAI Prusa Mendel i3 with the mk2a heatbed. I program the bed to reach 110ºC to print with ABS but it can not get past the 103 -104 °C. I have checked several times the connections and the welds. Even I solder better one wire that seems wrong weld. But no change. I have also no...