Geeetech

you can use the easy print for your rostock 301?

Thanks for your suggestion, we will see if we can add it to the next version.

here is a video for the Extruder calibration on geeetech i3 pro b 3D printer made by tintek33, hope it helps you to improve your printing quality.
https://youtu.be/fb7lit5ZRq4

Have you refresh the firmware for your new board?
GT2560 rev A board has no power supply from the USB anymore. when you refreshe the firmware, please be sure to power it up.

if you are using this geeetech Mk8 extruder, http://www.geeetech.com/assembled-mk8-extruder-p-857.html?zenid=qb548a7006hv7sibkdgd5b87i6 you may find it difficult to get the felament right to the barrel, with this filament guide,it will be much easier. he tested the 2mm version with filaflex, it work...

carlzoll wrote:I haven't purchased the printer yet. I was hoping to find out if it could before I give it a try...

i tried, but not that good, there is always jam in the barrel, so, do not risk it

IMG_0957b.jpg My extruder just started to sag as well. In my case, it because distorted in one direction from the combination of weight and heat. I think that the plastic is the same on that they use to 3D print the parts (ABS?) and it gets soft when the temperature of the extruder goes up. I am as...

That there sounds like a smartass comment. How can I recommend this printer to my customers if they are going to have the same problem? You don't buy a new car and then go and have to buy parts for it to make it work. Your response should have been "sorry for the trouble guys. We have shipped you n...

Thanks for your kind feedback, we will see how to do with the change you suggest and we will try to take more reinforcement measure to ensure the stable of the rods. thanks

how could this happen? is there any cracks on the part? do you think it can make it if i send you the stl file for this support plate. if not i will send you another one.