Geeetech

I've reconfigured a new Marlin 2.0.x firmware for this printer. So I can configure everything myself again.

Got myself 5 measuring points in the X and Y axis when probing, staying 17mm clear of the bed border. Which gives me a pretty good coverage and stays clear of the clamps.

I'm trying to calibrate my new A20M. And I think one of the most important steps to start with is to calibrate the E-steps. I've noticed that there's a lot of diffrences about this value in several sourcecodes for this specific printer. Varriating from 395 to 430. When I just measured and calculated...

I think cable management on the A20M is really terrible. Really don't know how they could had designed something like this. Extruder cables are way to short and will get in the way of the printbed or the hotend cable. The people of Geeetech could had found this out when trying to build up a kit them...

I've upgraded my A20M with an 3D-touch probe. But I would like to adjust the grid a bit. I need to make some changes for this in the firmware. But I completely don't have a clue on how to get to the "Configuration.h". Alternatively I was thinking making the adjustments to firmware file and upload it...